FPGA Board for EIC Measurement Data Collection

Open tender

Japanese title: EIC 測定器データ収集用 FPGA ボード

Research
About this page
This page is based on the official tender notice and presents information processed, translated, and edited by JBid.

Overview

Procurement of an FPGA board intended for data collection from EIC measurement instruments by RIKEN. The notice specifies the acquisition of specialized hardware for scientific data acquisition.

Key Details

  • Source: OfficialPublisher
  • Notice type: Open tender
  • Publication date: October 19, 2026
  • Procuring entity: RIKEN (National Research and Development Agency)
  • Submission deadline: November 4, 2026
  • Status: Active
  • Technology relevance: Possible
  • Business-action likelihood: Medium – The procurement is for specialized scientific hardware which may require local partnerships or adaptation; the notice provides a standard deadline allowing some preparation time.

Official Notice

Official Source

RIKEN (National Research and Development Agency), an official Japanese procuring entity publishing its own tender notices on its official website.

  • Source: RIKEN (National Research and Development Agency)
  • Official category: Tender notice
  • Publication date: October 19, 2026
  • Publication: Official publication

Full English Translation

The following English translation was prepared from the original Japanese notice published by RIKEN (National Research and Development Agency) on its official website. The translation below is based on the Japanese source text.

EIC 測定器データ収集用 FPGA ボード
Show original Japanese notice

EIC 測定器データ収集用 FPGA ボード

Business Signal

Business Relevance

Potential relevance requires a targeted fit check. Confirm the supplier's documented capabilities against the actual requirements and verify a participation route.

  • Product fit: Potential
  • Current-case feasibility: Unknown
  • Evidence confidence: Low
  • Supply-chain security: Unknown

Participation fit

Participation is expected to require appropriate Japanese government procurement eligibility, or cooperation with a suitable Japanese partner holding the required qualification. The eligibility requirements have not been fully reviewed and should be verified against the official tender documents.

This page is based on the official tender notice published by RIKEN (National Research and Development Agency) on its official website, with translation and a preliminary business assessment by I.J. Do. The official Japanese text and tender documents are authoritative.

JBid is a beta technology-procurement intelligence service by I.J. Do.

Back to daily list

Source: RIKEN (理化学研究所). Translation and editing: JBid / I.J. Do. The official Japanese text is authoritative.